Give a damp cloth room to hang.

Two rounded triangular frames joined by a continuous curved crown, standing on an oval tray. Drape a dishcloth over the crown so the cloth hangs on both sides, while drips fall into the tray.

How it works

Hang the cloth over the curved crown and spread the two hanging sides apart. Water can drip onto the tray below.

Design features

• Continuous curved crown joins the two frames

• Two triangular frames keep the stand stable

• Shallow tray catches drips

• Overall size 156.0 x 84.0 x 74.0 mm

Colors

Shown in slate teal. This is a single-piece print; use any filament color you like.

Print setup

Print on the tray base. Supports were enabled in the test slice. Inspect overhangs in your slicer before printing and remove supports carefully.

Suggested starting point: 0.2 mm layers, 3 perimeters, 20% infill. Adjust for your printer and material. The test slice used a 250 x 250 mm bed.

Build and use

Step 1. Print on the tray base with supports as required by your slicer.

Step 2. Remove the supports without loading the frames.

Step 3. Place the stand on the counter.

Step 4. Drape the cloth over the curved crown and spread the hanging sides apart.