Water, and you’re all set.
Water, and you’re all set. by admin is licensed under the
C-Attribution - Noncommercial - Share AlikeLicense
- Description
- Build Instruction
- Remixes
Size: Large (more than 10cm)
Introducing the first design from Parallel Goods. This Self-Watering Planter is exactly the growing environment your plants need, while giving you flexibility in your watering routine. It’s super easy to use: just plant your favorite herb or other water-intensive plant, add water, and you’re all set. The Self-Watering Planter was designed to be 3D printed, easy to setup, use and clean; while at the same time allow for customization through mixing and matching different colors for the pot and reservoir. Be sure to check out the Instructions tab to make sure you get the most out this Self-Watering Planter. Ornamental Bulbasaur Dont forget to Like How to Patina a 3d Print in 3 Steps Sub to my channel Check out my Patreon if you want early access to my newest files or if you want to sell prints! __________________________________________________________________________ Dont forget to like him here and share your makes! Print Settings Printer brand: Creality Printer: Ender 3 Rafts: No Supports: Yes
License
Water, and you’re all set. by admin is licensed under the
C-Attribution - Noncommercial - Share AlikeWater Tight PLA Slic3r Settings Layer Height: .3mm Vertical Shells (Perimeters): 3 Horizontal Shells (Solid Layers): Top – 4, Bottom – 4 Infill: 10% - Speed: Top Solid Infill – 15mm/s, Solid infill – 15mm/s Prints WITHOUT Supports The extra top & bottom shells combined with the slow solid infill print speeds ensure a thick and even wall for the bottom of the reservoir which provides water tight print. Your mileage may vary, but these settings should give you a fine starting point for use on your own printer.
Add a commentComments
admin
admin
admin
admin
admin